![]() Is this a bug? Depending on what it takes to get back to sanity, and whether there's pilot error on my part, there might be user traps. Maybe I should just stick with 44100 and let the video people convert it to 48k?Īt this point it seems like I need to, 1, figure out how to get the pitch and data rate to stay the same throughout the process, then 2, redo the vocals.Īny advice on how to get back to sanity here? Maybe I should have a 440 Hz and a 1 kHz file at the ready to confirm that the recorded pitches and the exported pitches turn out the same? The original piano track, and the composite track have exactly the same duration in time, 2 min., 16 sec. I don't know that this is the cause of the problem I experienced. But, there's also a line in the config file that says that ALSA runs at 48000. I see that the song says its rate is 44100, and a line in the config file say that JACK runs at 44100. Using these keyboard modifiers you can adapt Mixbus to the editing workflow you prefer. Just now I looked in the ardour file for the song, and in ~/.config/mixbus7/config for lines containing "sample-rate". This section allows you to change the keyboard modifiers Shift, Command, Control, Alt, as well as the lesser-used Windows keys, and combinations thereof, when using the mouse to click, drag, and trim in the Editor window. After some fiddling I found that the vocals were too low in pitch by the relative pitch shift from 48k to 44.1k. Before the client left I wanted to check that the CD burned fine and played the CD in a boom box. At that point we exported the mix and burned it to a CD. Upon playback all attention was on the new vocals, which turned out nicely. I imported the client's piano track from a CD into the session. I started a new project, and used the JACK dialog window which pops up at the beginning of a session to set the sample rate to 44.1 kHz. Today I needed to record at 44100 at the client's request. ![]() I've been recording tracks for a project that incorporates video, so have been at 48000 for a while now. I had a difficult day with sample rates and pitches today.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |